Sequential Turn Signals    Sequential Turn Signals
  Sequential Turn Signals
 Solid State Circuitry

 Self-Adjusting Electronics assures
 Perfect Sequencing Action!

 Programmable Brake Light Operation

 Works on All Multiple Signal Cars

 Works with LEDs or Standard Bulbs

   


If you have two or more turn signal filaments on each side of your car, you can add the STS-1, STS-2, or STS-4 Sequencer Kit and really indicate your intentions.

These modules feature sophisticated electronics that automatically adjust the sequencing speed to match the turn signal flasher in your car.  While other products offer you fixed timing or complicated manual adjustments, our modules sense your car's flasher speed and adjust the 1-2-3 sequence timing for you.  Want more separation between individual lamps?  Just put in a slower flasher!

If your car has combination stop/turn signal lamps, these modules will sequence the turn and emergency flashers only.  The brake lights operate normally!  However, if you also want a single brake light sequence (called "brake light burst"), these modules will do it.  Your Choice!

Each kit comes with 2 modules (one for each side of the car), wire, connectors and printed instructions.  Installation takes about an hour, and for most cars, only basic hand tools are required!


    Qty  
  STS-1 Sequential Turn Signals,  $69 ..........  
                    - For cars with 3 lamps on each side    
    Qty  
  STS-2 Sequential Turn Signals,  $49 ..........  
                    - For cars with 2 lamps on each side    
    Qty  
  STS-4 Sequential Turn Signals,  $79 ..........  
                    - For cars with 4 lamps on each side    

 

 

  Note:  Sequential Turn Signals only work on cars with combination brake/turn signal lamps.  If your car has separate amber or red turn signals you need to install a trailer converter module, which can be purchased at your local car parts store.
 
  Copyright WebElectric Products, LLC. All rights reserved.